Reverser Spray effect for FS2004 only.

******************************************************************************************************************************

This new effect will simulate water or snow being blown when the reverser is deployed, elevating the landing 
experience on a wet runway.
This effect comes with a gauge will automatically activate the effect only work when the reversers are deployed and if it is raining or snowing.
This is easy to install and is not limited to POSKY planes.
Installation instructions are included.

If you would like to see the effect in action check these videos:

http://uk.youtube.com/watch?v=jMvnuJJb3fI

http://uk.youtube.com/watch?v=XHFZmPoVdIw

http://uk.youtube.com/watch?v=zMnlyT1z73g

***********************************************************************************************************************

Installation:
---------------------------------------------------------------------------------------------------------------------------------------------------------------
The effect file fx_revspray.fx goes in your main FS effects folder.

The cab file revspray.cab goes in your main FS gauges folder.

-----------------------------------------------------------------------------------------------------------------------------------------------------------

Then you need to place into the smoke system section of your aircraft cfg the appropriate lines

E.g for the POSKY 747 v4:

[SMOKESYSTEM]
smoke.0 = -18.030,  -106.400,   -70.083333,   Opensky_revspray
smoke.1 = -18.030,  -76.300,   -40.916667,    Opensky_revspray
smoke.2 = -18.030,  -76.300,   40.916667,    Opensky_revspray
smoke.3 = -18.030,  -106.400,   70.083333,    Opensky_revspray

       for the HNAC A-300:

[SMOKESYSTEM]
smoke.0 = -18.030,  20.920,   -27.050,    Opensky_revspray
smoke.1 = -18.030,  20.920,   27.050,    Opensky_revspray 

To set it up for other aircraft look for the [GeneralEngineData] section you will see the first section of the line Engine.0
will be the same as the second section of smoke.0 
The second section of Engine.0 will be the same as the last section of smoke.0
Just leave the first section of smoke.o ....it will make no difference.
--------------------------------------------------------------------------------------------------------------------------------------------------------------

And in the Window00 section of you panel cfg this line (replacing the xx with the next number that follows the last gauge line in that section :

gaugexx=revspray!revspray,      0,0,10,10               // Reverser splash

************************************************************************************************************************************
FREEWARE

17/08/2007

Credits and copyright :- Edward Cox- ProjectOpensky Panel designer and Texture Artist. 
email: edetroit@gmail.com or edetroit@projectopensky.com

Conditions of use
-----------------
The software contained in this archive is supplied for your use as "freeware".  No fee or charge is made for its use.  

The original author retains full ownership of these files and reserves all rights and privileges under U.S. and international copyright laws.  

This package may be redistributed freely provided that the entire package is distributed, as is, without any modifications whatsoever.  Enhancements such as repaints, panels, sound files, etc must be distributed seperately as stand-alone files and may not be inluded in the original package.


No fee or charge may be made by any third party for the use or distribution of this software under any conditions, without the express permission of the author.


